inverter setting values. 440 volt inverter OUTPUT VOLTAGE LIMIT OPTIONS OF 440 VOLT INVERTER. 0: DISABLED. 1:EFFECTIVE THE MOTORS FLUX FALLS AUTOMATICALLY WHEN THE OUTPUT VOLTAGES REACHES SATURATION STATUS. INVERTER/MOTOR CURRENT. NOTE: OUTPUT VOLTAGE LIMIT ACTION IS DISABLED , IF THE OUTPUT VOLTAGE REACHES SATURATION STATUS, THE OUTPUT CURRENT HAS NO CHANGE BUT THE TORQUE … Read more
TORQUE CONVERTER / INVERTER. use for control starting load when this function is used the start torque converter compensation is set by command mechanical friction load , for the elevator.the setting of torque converter start torque rising time is in unit of Mr s(note )filter delay is disabled when the setting is between 0~4 ms NOTE: … Read more
ELECTRIC INVERTER carrier frequency is 2 k Hz . 1:carrier frequency is the setting of c 6-0 1. 2: carrier frequency is 5 k Hz electric inverter carrier frequency of the inverter of 400 v is 2.5 Hz ) 185 ~ 300 kw .normally electric inverter is not necessary to change this setting , fine … Read more
electric inverter frequency reference when the multi function inputs jog frequency reference selection f jog command and r jog command are on.the electric inverter frequency reference default value and set value will change when 0 1-0 3 is changed, for example if preset reference 1 is set to 6.00 Hz and 01-03 is changed … Read more
TORQUE REFERENCE DELAY TIME . the primary delay time constant of torque command filter is set in unit of m r s to adjust the electric inverter torque reference time constant of the primary delay filmier . to adjust the noise of the torque control signal or the responsive nests with the host controller … Read more
set only to fine adjust v/f for the output range when using flux vector control of frequency speed and voltage of inverter .normally this setting range and factory setting will be cut by 50% for the inverter of 200v class . to set the constant e 1-0 4 ~e 1-10 when e 1-0 3 =”f” … Read more
motor system in inverter MOTOR 2 LINE TO LINE RESISTANCE . To set the motor,s line to line resistance in unit of ohm . note: the factory setting depends on the capacity of the inverter . please set the motor,s line to line resistance u v v – w w u normally you need to … Read more
OPERATION SELECTION AT OVER SPEED/ DEVIATION . winner inverter set the stop method when over speed occurs.0:deceleration to stop using deceleration time 1 (c 1-0 2). 1: coast to stop. 2: emergency stops using the emergency stop time ( c 1-0 9). 3:continue operation it dose not need to be set normally to protect the … Read more
inverter speed value . In the realm of modern technology, the concept of “inverter speed value” has emerged as a pivotal factor in the efficient operation of various electronic devices and systems. As we delve into this intricate subject, we aim to provide an in-depth, comprehensive understanding of this crucial component, its functionality, and its … Read more
DIGITAL SYSTEMS INPUT OPTION OF INVERTER. To set the input method of digital command card . 0: bcd . 1% 1: bcdo . 1% 2: bcdo. 01% unit 3: bcd 1Hz unit. 4:bcdo . 1 Hz unit 5:bcdo. 1Hz unit . 6: bcd special setting (5-digital input) . 7: binary system. note: when … Read more