ENERGY SAVING this is the frequency lower limit within the effective range of energy saving control . it is set in unit of Hz . please set the frequency lower limit within the effective range of energy saving control. energy saving command . it starts only from the frequency which is above the lowest energy […]
ELECTRIC INVERTER carrier frequency is 2 k Hz . 1:carrier frequency is the setting of c 6-0 1. 2: carrier frequency is 5 k Hz electric inverter carrier frequency of the inverter of 400 v is 2.5 Hz ) 185 ~ 300 kw .normally electric inverter is not necessary to change this setting , fine […]
Finding the Best Inverter Dc to Ac inverter dc to ac Inverter Dc to Ac – Overview Generally, as soon as an inverter is in over-power mode, it simply suggests that it’s going to sacrifice the surplus power. There are not any inverters used inside the computer system. The smallest inverters are somewhat more portable […]
PANEL/REMOTE SETTING VALUE 1. OFF:To select frequency command (b1-01) and operation command (b1-02). ON : Set frequency command/operation command by digital operator . To switch the input method between frequency command and operation command . To switch only at the stop of inverter . Once the function was set digital keyboard operation method selection key […]
Win- va /vc,s deceleration / acceleration time has 4 options , to switch between these time option , please set deceleration / acceleration time option 1 ,2 at multi function input . setting value 7 = acceleration / deceleration time selection 1 . setting value 1 a = acceleration / deceleration time selection 2 . […]
When terminal 14 is used as frequency command please h3-09 (frequency command (current ) terminal 14 function selection ) to be if otherwise if you use this function fault (o p e 03) will occur . when h3 -09 (frequency command ( current ) terminal 14 function selection ) is set as if but […]
It is the function to control the inverter,s output frequency through the control terminal,s on/off . when using this function please make sure to set the 2 multi function input up/down command .if only to set single multi function input the fault ope 03 will occur .besides in the occasion where acceleration /deceleration stop was […]
In the occasion where up/down was set multi step peed command 1~8 will be all non effective . the dwell output frequency when up/down is on will be memorized by the value of d4-01 (dwelling function option of frequency command) the setting value is 1 . the value will be recorded after the power is […]
TO CANCEL PID CONTROL off = pid control is enabled . on = pid control is disabled ( normal control of inverter ) with this setting ,the multi – function input switches between pid control and normal inverter control . this function can be used to perform trial operation or jog operation with normal inverter […]
EXTERIOR FAULT ,(SETTING,20-2 F) This is to set how to output the warning to exterior when the exterior equipment is at fault or in a abnormal status and the inverter stops. as the input condition for exterior fault , it can choose the inverter,s action when the exterior is input . the following setting […]
