electric inverter frequency

  electric inverter frequency reference when the multi function inputs jog frequency reference selection f jog command and r jog command are on.the electric inverter frequency reference default value and set value will change when 0 1-0 3 is changed, for example if preset reference 1 is set to 6.00 Hz and 01-03 is changed […]

motor system

motor system in inverter MOTOR 2 LINE TO LINE RESISTANCE . To set the motor,s line to line resistance in unit of ohm . note: the factory setting depends on the capacity of the inverter . please set the motor,s line to line resistance u v v – w w u  normally you need to […]

inverter speed value

    inverter speed value . Enable /disable integral value during ace/decal , 0: disable (the integral function is not used while accelerating or decelerating : it is used at constant speed). 1: enabled (the integral function is used at all times), note: when v/f control with pg feedback is used integral control during acceleration […]

digital systems

    DIGITAL SYSTEMS INPUT OPTION OF INVERTER. To set the input method of digital command card . 0: bcd . 1% 1: bcdo . 1% 2: bcdo. 01% unit 3: bcd 1Hz unit. 4:bcdo . 1 Hz unit 5:bcdo. 1Hz unit . 6: bcd special setting (5-digital input) . 7: binary system. note: when […]

3 phase inverter

3 PHASE INVERTER OUTPUT MODE SELECTION . Set the 3 phase inverter  output  mode  in the following constants when using a d0-08 digital output card 0: – channel individual outputs  code output ( binary system code) . note: the item output by d0-08 according to f6-01 setting , please set the code output as follows. […]