TORQUE CONVERTER / INVERTER. use for control starting load when this function is used the start torque converter compensation is set by command mechanical friction load
Tag: POWER INVERTER KVA SELECTION.
electric inverter carrier frequency
CARRIER FREQUENCY set the upper limit and lower limit in K Hz units . the carrier frequency gain is set as follows . frequency
electric inverter frequency
electric inverter frequency reference when the multi function inputs jog frequency reference selection f jog command and r jog command are on.the electric inverter
electric inverter torque reference
TORQUE REFERENCE DELAY TIME . the primary delay time constant of torque command filter is set in unit of m r s to adjust
motor system
motor system in inverter MOTOR 2 LINE TO LINE RESISTANCE . To set the motor,s line to line resistance in unit of ohm . note:
WINNER,S OPERATION SELECTION AT OVER SPEED
OPERATION SELECTION AT OVER SPEED/ DEVIATION . winner inverter set the stop method when over speed occurs.0:deceleration to stop using deceleration time 1 (c 1-0
inverter speed value
inverter speed value . Enable /disable integral value during ace/decal , 0: disable (the integral function is not used while accelerating or decelerating
digital systems
DIGITAL SYSTEMS INPUT OPTION OF INVERTER. To set the input method of digital command card . 0: bcd . 1% 1: bcdo .
3 phase inverter
3 PHASE INVERTER OUTPUT MODE SELECTION . Set the 3 phase inverter output mode in the following constants when using a d0-08 digital output card
working of inverter
FUNCTION TABLE OF MULTI FUNCTION INPUT (H1). 0: 3 line system program control (forward / reverse command ). 1: local / remote selection (on operator