power inverter electric inverter solar inverter 440 VOLT INVERTER
ACCELERATION/DECELERATION TIME SETTING UNIT. the acceleration time when multi function input emergency stop is on.0:unit:0.01 second 1:unit:0.1 second. note:to set more precisely the acceleration time,please set c 1_10 to be …
Read MoreSLIP COMPENSATION GAIN. this function is used to improve speed accuracy when operating with a load .setting range is 0.0~2.5 and factory setting is 1.0 . NOTE: this constant …
Read MoreOUTPUT VOLTAGE LIMITED OPERATION SELECTION. OUTPUT VOLTAGE LIMIT OPTIONS, 0: DISABLED. 1:EFFECTIVE THE MOTORS FLUX FALLS AUTOMATICALLY WHEN THE OUTPUT VOLTAGES REACHES SATURATION STATUS. NOTE: OUTPUT VOLTAGE LIMIT ACTION …
Read MoreSTART TORQUE CONSTANT. the setting of start torque rising time is in unit of Mr s (note )filter delay is disabled when the setting is between 0~4 ms NOTE: when …
Read MoreCARRIER FREQUENCY set the carrier frequency upper limit and lower limit in K Hz units . the carrier frequency gain is set as follows . frequency is fixed at …
Read MoreAFR GAIN. 0: carrier frequency is 2 k Hz . 1:carrier frequency is the setting of c 6-0 1. 2: carrier frequency is 5 k Hz (the carrier frequency of …
Read MoreJOG FREQUENCY REFERENCE. the frequency reference when the multi function inputs jog frequency reference selection f jog command and r jog command are on. NOTE: the frequency reference default value …
Read MoreTORQUE REFERENCE DELAY TIME . the primary delay time constant of torque command filter is set in unit of m r s NOTE: to adjust the time constant …
Read Moreset only to fine adjust v/f for the output range when using flux vector control .normally this setting range and factory setting will be cut by 50% for …
Read MoreMOTOR 2 LINE TO LINE RESISTANCE . To set the motor,s line to line resistance in unit of ohm . note: the factory setting depends on the capacity of the …
Read More