ENERGY SAVING this is the frequency lower limit within the effective range of energy saving control . it is set in unit of Hz . please set the frequency lower limit within the effective range of energy saving control. energy saving command . it starts only from the frequency which is above the lowest energy … Read more
INVERTERS ACCELERATION/DECELERATION TIME SETTING UNIT. the acceleration time when multi function input emergency stop is on.0:unit:0.01 second 1:unit:0.1 second.note:to set more precisely the acceleration time,please set c 1_10 to be 0. but the setting range in narrow. TIME SWITCHING FREQUENCY. set the frequency for automatic acceleration/switching below set frequency acceleration/deceleration time 4.above set frequency.acceleration/deceleration time … Read more
this becomes the gain to compensate for slip caused by motor temperature variation when motor,the temperature rise by converting it into slip compensation of inverter. its show inverters value. SLIP COMPENSATION GAIN OF INVERTER this function is used to improve speed accuracy when operating with a load .setting range is 0.0~2.5 and factory setting is … Read more
inverter setting values. 440 volt inverter OUTPUT VOLTAGE LIMIT OPTIONS OF 440 VOLT INVERTER. 0: DISABLED. 1:EFFECTIVE THE MOTORS FLUX FALLS AUTOMATICALLY WHEN THE OUTPUT VOLTAGES REACHES SATURATION STATUS. INVERTER/MOTOR CURRENT. NOTE: OUTPUT VOLTAGE LIMIT ACTION IS DISABLED , IF THE OUTPUT VOLTAGE REACHES SATURATION STATUS, THE OUTPUT CURRENT HAS NO CHANGE BUT THE TORQUE … Read more
TORQUE CONVERTER / INVERTER. use for control starting load when this function is used the start torque converter compensation is set by command mechanical friction load , for the elevator.the setting of torque converter start torque rising time is in unit of Mr s(note )filter delay is disabled when the setting is between 0~4 ms NOTE: … Read more
CARRIER FREQUENCY set the upper limit and lower limit in K Hz units . the carrier frequency gain is set as follows . frequency is fixed parameters at electric inverter c 6-0 1 c 6-0 1>10.0 k=3 10.0>c 6-0 1>5.0:k=2 5.0>c 6-0 1:k=1 NOTE: in vector control , the carrier frequency is set by … Read more
ELECTRIC INVERTER carrier frequency is 2 k Hz . 1:carrier frequency is the setting of c 6-0 1. 2: carrier frequency is 5 k Hz electric inverter carrier frequency of the inverter of 400 v is 2.5 Hz ) 185 ~ 300 kw .normally electric inverter is not necessary to change this setting , fine … Read more
electric inverter frequency reference when the multi function inputs jog frequency reference selection f jog command and r jog command are on.the electric inverter frequency reference default value and set value will change when 0 1-0 3 is changed, for example if preset reference 1 is set to 6.00 Hz and 01-03 is changed … Read more
TORQUE REFERENCE DELAY TIME . the primary delay time constant of torque command filter is set in unit of m r s to adjust the electric inverter torque reference time constant of the primary delay filmier . to adjust the noise of the torque control signal or the responsive nests with the host controller … Read more
set only to fine adjust v/f for the output range when using flux vector control of frequency speed and voltage of inverter .normally this setting range and factory setting will be cut by 50% for the inverter of 200v class . to set the constant e 1-0 4 ~e 1-10 when e 1-0 3 =”f” … Read more