TO CANCEL PID CONTROL
off = pid control is enabled .
on = pid control is disabled ( normal control of inverter )
with this setting ,the multi – function input switches between pid control and normal inverter control . this function can be used to perform trial operation or jog operation with normal inverter control (open -loop control ) and then switch to pid control (closed -loop control using feedback) after adjusting . the system. the pid disable function can also be used to switch to open – loop control when there is a problem with the feedback value?
PARAMETERS INPUT PERMISSION (SETTING ;1 B )
off = the constants can,t be written except frequency display
on= the named constant can be input in the model of environment setting.
constant inhibition / permission from keyboard can be operated from exterior . when constant permission is off , you can only change the monitored frequency in driving mode.
SPEED COMMAND ( SETTING ; I C )SPEED COMMAND ( SETTING : ID)
output speed = +speed command – speed command
speed command + d 4-02 = on off
speed command -d 4-02 = off on
speed command =on on
speed command = off off
speed command . the analog frequency command added by a certain value of frequency works as output frequency .
speed command , the analog frequency command minus a certain value of frequency works as output frequency .
this function is effective only when is input from analogy terminal and frequency command is used .
set one of the constant amount h1-01 ~06 (multi function input ) to be 16 (motor 2 selection command ) the action will be open or closed by input signal . and the inverter interior memorized control modes /f characteristics motor constants can be changed . set one of the constant among h2-01 ~03 (multi function output )to be 1 c (motor selection monitoring ) and then multi -function output terminal can monitor the current motor selection status .
please set the environment setting constant ,cancel level a1-01 to be 3 (basic ) or 4 (ADVANCED) the following constants will be replaced according to motor 2 selection ( switching) command .
NOTE; following the switching of the motors, the below constants will be initialized when A1 -02 in not equal to E3 -01; b3-01 ,b3-02 ,c3-01,c3-02,c4-02,c5-01,c5-02 ,c5-03,c5-04,e1-04,e4-01,e1-05,e1-06,e4-03,e1-07,e4-04,e1-08,e4-05,1-09,e4-06,e1-10,e4-06,f1-09.
please find below for the time sequence of operation when switching from motor 1 to motor 2.
Hello, Neat post. There’s an issue together with your web site in web explorer, would test this… IE nonetheless is the marketplace leader and a large part of people will omit your magnificent writing due to this problem.
I enjoy the efforts you have put in this, thanks for all the great blog posts.
Thanks for sharing. I read many of your blog posts, cool, your blog is very good.
Thank you for your sharing. I am worried that I lack creative ideas. It is your article that makes me full of hope. Thank you. But, I have a question, can you help me?