Wed. Oct 30th, 2024

     

    POWER INVERTER KVA SELECTION.

    donot change this constant setting note : the setting range and factory setting
    depend on the inverter capacity

    frequency reference setting method selection of power inverter.

    this constant determines wether it is necessary to press the enter key when changing
    the frequency reference with the digital operator’s frequency reference monitor
    0: data / enter key input required . 1: data / enter key not  required  .
    note : it cannot be changed during operation . wen 02- 05 i set to 1 (data / enter
    key input not required ) the frequency reference changes simultaneously with the
    digital operators’ value of power inverter.

     

    operation selection when digital operator is disconnected

    sets the operation when the digital operator is disconnected  0: disable ( operataion
    continues even if the digital operator is disconnected.) 1: enable opr is detected
    at digital operator disconnecton . invertor output is cut off and fault contact is
    operated .)

    cumulative operation time setting of power inverter.

    et the initial elarsed time in constant 02-07 in unit of hours . note: the elapsed
    operating time will start from this value .

    cumulative operation time selection.

    the calculation of accumulative time.
    0:accumulative time when the inverter power is on .(all time while the inverter power
    is on is accumulated.)1:cumulative power inverter run time ,(only power inverter output
    time is accumulated).
    initialize mode selection of power inverter (please do not modify).



    3 thoughts on “POWER INVERTER KVA SELECTION.”
    1. Today, while I was at work, my cousin stole my iphone and tested to see if it can survive a 40 foot drop, just so she can be a youtube sensation. My iPad is now broken and she has 83 views. I know this is totally off topic but I had to share it with someone!

    Leave a Reply

    Your email address will not be published. Required fields are marked *