see how to make free energy with motor and inverter . A procedure will just happen precipitously, without included energy, in the event that it builds the entropy of the universe in general (or, in the limit of a reversible procedure, abandons it unaltered) – this is the Second Law of Thermodynamics. Be … Read more
FREQUENCY / SPEED OF CURRENT. frequency is speed round per min Hz inverter is the best device for control frequency : Hz : and control current speed / motor speed . frequency after plus minus calculation of analog frequency command . it is in unit of% with the maximum out put frequency taken as 100 … Read more
ENERGY SAVING this is the frequency lower limit within the effective range of energy saving control . it is set in unit of Hz . please set the frequency lower limit within the effective range of energy saving control. energy saving command . it starts only from the frequency which is above the lowest energy … Read more
this becomes the gain to compensate for slip caused by motor temperature variation when motor,the temperature rise by converting it into slip compensation of inverter. its show inverters value. SLIP COMPENSATION GAIN OF INVERTER this function is used to improve speed accuracy when operating with a load .setting range is 0.0~2.5 and factory setting is … Read more
inverter setting values. 440 volt inverter OUTPUT VOLTAGE LIMIT OPTIONS OF 440 VOLT INVERTER. 0: DISABLED. 1:EFFECTIVE THE MOTORS FLUX FALLS AUTOMATICALLY WHEN THE OUTPUT VOLTAGES REACHES SATURATION STATUS. INVERTER/MOTOR CURRENT. NOTE: OUTPUT VOLTAGE LIMIT ACTION IS DISABLED , IF THE OUTPUT VOLTAGE REACHES SATURATION STATUS, THE OUTPUT CURRENT HAS NO CHANGE BUT THE TORQUE … Read more
TORQUE CONVERTER / INVERTER. use for control starting load when this function is used the start torque converter compensation is set by command mechanical friction load , for the elevator.the setting of torque converter start torque rising time is in unit of Mr s(note )filter delay is disabled when the setting is between 0~4 ms NOTE: … Read more
CARRIER FREQUENCY set the upper limit and lower limit in K Hz units . the carrier frequency gain is set as follows . frequency is fixed parameters at electric inverter c 6-0 1 c 6-0 1>10.0 k=3 10.0>c 6-0 1>5.0:k=2 5.0>c 6-0 1:k=1 NOTE: in vector control , the carrier frequency is set by … Read more