SOLAR MAX INVERTER,S SPECIFICATIONS model 1.2K 2.4K Input voltage 230 VAC Voltage range 170-280 VAC(narrow mode) 90-280vac(wide mode) OUTPUT Voltage regulation (BATT.MODE) +/-10% Transfer time 20 ms typical Wave form Simulated since wave BATTERY Battery voltage 12vdc 24vdc Floating charge voltage 13.5vdc+_0.5 VDC 27.0vdc+_0.5vdc Maximum […]
Terminal s/n Content Specification Ta 1 1 Power supply for encoder Dc + 12v (+-5)max .20ma 2 Dc o v ( grounding terminal for power supply) 3 A phase pulse input terminal H : +8v ~12v L:>+ 1v (max, response frequency 30 Hz) 4 A phase pulse input terminal 5 B phase input terminal […]
NOTE : Before installation please inspect the unit be sure that nothing inside the package is damaged. Installation note before installation,please inspect the unit. be sure that nothing inside the package is damaged. Mountain the unit The unit only can be mounted vertically to a wall surface. please follow below steps: 1. Turn off […]
Signal level selection of multi function analogy terminal 14 0: 0~+ 10 volt please make sure to cut off the over line 1 1: 0 ~+_10 volt please make sure to cut off the over line 1 2: 4 ~ +_20 ma ( 10 bit input ) frequency (current ) it is effective when b1 _ […]
NO Name Description Setting range Factory setting Bias (terminal 14) The command value of each function when 0 v (4 ma)is input , the unit is % -100~ +100 0.0 H3-11 Note : as the adjustment constant of analog input it is classified into 3 types gain deviation ( to be set individually for […]
SOLAR MAX DC TO AC SOLAR INVERTER,S INSTALLATION AND HOW TO 24 DC VOLT WIRING NOTE: before installation please inspect the unit be sure that nothing inside the package is damaged. MOUNTING THE UNIT . The unit only can be mounted vertically to a wall surface. please follow below steps, 1. turn off the unit […]
440 VOLT INVERTER,S TERMINALS TABLE No Name Description Setting range Factory setting Change During Option Control methods v/f v/f with pg Open loop vector Flux vector H4-03 Bias (terminal 21) To set the voltage level deviation of multi function analog value output 1 and make the output characteristic to be parallel to the […]
No Name description Setting range Factory setting Change during operation Control methods v/f v/f with pg Open loop vector Flux vector H4-07 Analog output signal level selection The set signal output level of multi function analog value 1.2 (terminal 21,23)0:0~+10v 1:0~+_10v output note of setting : this signal level setting is suitable for multi […]
440 VOLT WINNER INVERTER,S MOTOR PROTECTION TABLE No Name Description Setting range Factory setting Change during operation Control methods v/f v/f with pg Open loop vector Flux vector L1-01 Motor protection selection Sets whether the motor overload function is enabled or disabled at electric thermal overload relay 0: disabled 1:enabled Note : this setting […]
SETTING OF INVERTERS. No Name Description Setting range Factory setting Change during operation Control methods v/f v/f with pg Open loop vector Flux vector L2-02 Momentary power loss ride thru time This setting is valid only when constant l 2-01 is set to 1. Set the power loss ride thru time in seconds. […]